tenibaC lortnoC eht gnitcurtsnoCsrellortnoC evirD 30EVIRDOCE 12-17
12.4 Wire routing in the Control Cabinet
• A distance of at least 100 mm between power and control or signal
cables (e.g., feedback cables) must be maintained or
• Separate cable duct with metal divider.
Metal cable duct
MB5008F1.FH7
2...4 mm
>100 mm
Plastic cable duct
Fig. 12-21: Cable duct variant
Note : Details are specied in the project planning manual
"Electromagnetic compatibility (EMC) or AC drives “, doc. Type
DOK-GENERL-EMV********-PRxx.
12.5 EMC in the Control Cabinet
Note : Details are specied in the project planning manual
"Electromagnetic Compatibility (EMC) in Drive and Control
Systems “, doc. type DOK-GENERL-EMV********-PRxx.
customerservice@hyperdynesystems.com | (479) 422-0390
To Next Page
Loading...
Need help?
General
