15-8 Replacing or Exchanging Drive Components ECODRIVE03 Drive Controllers
Replacing the Firmware Module
• Switch drive controller o
• Loosen screw at programming module and pull programming module
out
• Pull programming module out
• Open the lock on the back of the programming module
• Open the programming module
• Insert old parameter module into new rmware module
• Close lock (lock must be pushed outward)
• Insert programming module and screw on
• Switch drive controller on
Replacing the Programming Module (complete module)
• Secure parameters (DriveTop)
• Switch drive controller o
• Loosen screw at programming module and pull programming module
out
•
Insert new programming module
• Switch drive controller on
• Load parameters (DriveTop)
customerservice@hyperdynesystems.com | (479) 422-0390
To Next Page
Loading...
Need help?
General
