Rexroth Indramat ECODRIVE03 Series - What Is Needed to Prepare to Start-Up

tnemhcattAsrellortnoC evirD 30EVIRDOCE 16-27
16.5 What is needed to prepare to start-up
To start up an ECODRIVE drive system, the following is needed:
• Measuring equipment
• PC
• Linking cables (PC-drive controller)
To be able to read o torque, current and velocity in the form of analog
signals at the analog outputs, the following measuring equipment is
needed:
• Multimeter to take voltage readings (suces with a serial start-up)
• Oscilloscope or plotter (only needed to record signal paths when
commissioning a prototype)
The PC is needed to program, parameterize and diagnose when starting
up and servicing.
Hardware requirements:
• IBM co
mpatible
• min. 80486 microprocessor (Pentium 166 or higher recommended)
• at least 16 MB RAM memory
• hard drive with at least 80 MB available memory
• CD-ROM drive
• A free serial RS232 interface on the PC (COM 1 or COM 2)
Software pre-requisites:
• Windows 95/98, NT4.0, 2000, ME
• DriveTop start-up program
DKC**.3-040/100/200: See page 4-49 X2, Serial Interface resp.
DKC**.3-016: See page 5-23 X2, Serial Interface
Measuring devices
Personal computer (PC)
Link cables (PC-drive controller)
customerservice@hyperdynesystems.com | (479) 422-0390