2802 Forced Developer Churning
2802 1
Initializes the developer and checks the TD sensor output (Vt). The machine mixes the
developer for 2 minutes while reading and displaying the Vt value. The machine does not
initialize the TD sensor output. If the machine has not been used for a long period, prints
may have a dirty background. In a case like this, use this SP to mix the developer. The
message “Completed” is displayed when the program ends normally.
2906* Tailing Correction
2906 1
Shift value [0.0 to 1.0 / 0.0 / 0.1 mm/step]
Shifts the image position at the intervals specified by SP2-906-002. When the copier is
continuously printing vertical lines (such as in tables), the paper may not separate correctly.
This SP can prevent this.
2906 2
Interval [1 to 10 / 1 / 1 page/step]
Changes the interval of the image position shift specified by SP2-906-001.
2908 Forced Toner Supply
2908 1
Supplies the toner to the development unit. The processing stops under either of the
following conditions:
• The toner density in the development unit reaches the standard level.
• The processing has continued for two 2 minutes.
2915* Polygon Mirror Motor Idling Time [0 = None / 1 = 15 s / 2 = 25 s]
2915 1
Specifies the polygon mirror motor idling time. The polygon mirror motor starts its operation
when an original is set, a key is pressed, or the platen cover or DF is opened. The motor
stops if no manual operation is performed for the specified time. When you set “0”, the
motor does not stop while the copier is in the standby status.
2921* Toner Supply Mode
2921 1
[0 = Sensor 1 / 1 = Sensor 2 (DFU)]
Selects the toner supply mode. Keep the default setting as long as the TD sensor is working.
2922* Toner Supply Time [0.1 to 5.0 / 0.6 / 0.1 s/step]
5. Service Tables
140
To Next Page
Loading...
