Mode Adjustments
As a service person, you can use SPs 4-922 to 4-932 to further customize each of these original modes
to meet specific user requirements. If the user is experiencing a problem with copy, however, SP-based
adjustment should be the last step. Always proceed as follows:
1. First, try changing the density notch setting.
If that doesn't resolve the problem, then...
2. Try selecting a different original mode.
If that also doesn't resolve the problem, then...
3. Try customizing the relevant original mode with SPs.
To customize...
First use SP4-921 to select the original mode that you wish to customize. Then enter the relevant
customizations using SP4-922 to SP4-932. Refer to Section 5 for general information about the adjustments
you can make .
Note the following points:
• All SP settings are relative to the selected original mode. If you set the SP value to "0", the machine
will use the default processing for that mode.
• If you enter an SP customization setting for an original mode that does not support that customization,
the entry will have no meaning.
Image Processing
257
To Next Page
Loading...
