0: 1, 1: 1/32, 2: 1/16, 3: 1/8, 4: 1/4, 5: 1/2
005
Smooth Level [0 to 7 / 0 / 1/step]
Adjust the smooth level. This setting is only activated for the specified mode with
SP4-921-004.
0: None, 1: Level 1 to 7: Level 7
006
Brightness [0 to 255 / 128 / 1/step]
Adjust the brightness level. This setting is only activated for the specified mode with
SP4-921-004.
007
Contrast [0 to 255 / 128 / 1/step]
Adjust the contrast level. This setting is only activated for the specified mode with
SP4-921-004.
4941* White Line Erase [0 to 2 / 1 / 1/step]
4941 1
Selects the white line erase level.
0: None 1: Weak 2: Strong
• This setting is effective for all modes.
• 0: White line erase is not used, and white level correction is used instead·
• This setting is applied regardless of what mode has been selected in SP4-921.
4942* Black Line Erase [0 to 3 / 2 / 1/step]
4942 1
Selects the black line erase level. This setting is effective only when originals are scanned
by the DF.
[0 = No / 1 = Very weak / 2 = Weak / 3 = Strong]
This setting is applied regardless of what mode has been selected in SP4-921.
SP5-XXX (Mode)
5001 All Indicators On
5001 1
Turns on all LEDs. The LCDs turn on and off every 3 seconds. Press the reset key to end this
program.
5024* mm/inch Selection
5. Service Tables
152
To Next Page
Loading...
