Rigol DP2000 Series Programming Guide

Description
Waits for all the pending operations to complete before executing any other
commands.
Parameter
None.
Remarks
When "BUS" (Bus trigger, namely software trigger) is selected, this command can
ensure synchronization. After the command is executed, the instrument will wait for
all the pending operations to complete before executing any other commands.
Return Format
None.
Examples
*WAI /*Waits for all the pending operations to complete before
executing any other commands.*/
4.4 :INSTrument Commands
:INSTrument commands are used to select the channel to be programmed or query
the channel currently selected.
4.4.1 :INSTrument:NSELect
Syntax
:INSTrument:NSELect < n >
:INSTrument:NSELect?
Description
Selects the channel to be programmed or queries the channel currently selected.
Parameter
Name Type Range Default
<n> Discrete {1|2|3} 1
Remarks
• The parameters 1, 2, and 3 represent CH1, CH2, and CH3 respectively.
• This command uses numbers to substitute the channel identifiers
in :INSTrument[:SELEct] . It functions the same as :INSTrument[:SELEct]
and :INSTrument[:SELect] .
Command System
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
31

Rigol DP2000 Series Specifications

General

Voltage Resolution	1 mV
Current Resolution	1 mA
Type	Programmable DC Power Supply
Output Channels	1, 2
Output Voltage Range	0-30V
Current Accuracy	0.1% + 5mA
Ripple & Noise (CC)	≤3 mArms
Interface	USB, LAN
Display	4.3 inch LCD