Examples
:SYST:COMM:LAN:APPL /*Applies the network parameters currently
set.*/
4.11.5.2 :SYSTem:COMMunicate:LAN:AUTOip[:STATe]
Syntax
:SYSTem:COMMunicate:LAN:AUTOip[:STATe] <
bool
>
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]?
Description
Sets or queries the on/off state of Auto IP.
Parameter
Name Type Range Default
<bool> Bool {0|1|ON|OFF} ON|1
Remarks
• Before using the LAN interface, please use the network cable to connect the
instrument to your PC or to the network of the PC.
• The instrument provides three IP configuration modes: DHCP, Auto IP, and
Manual IP.
• When operating in Auto IP mode, the instrument automatically acquires the IP
address from 169.254.0.1 to 169.254.255.254 and subnet mask 255.255.0.0
according to the current network configuration.
• When all the three configuration modes are set to "On", the priority of
parameter configuration is "DHCP", "Auto IP", and "Manual IP". Therefore, to
use the Auto IP configuration mode, “DHCP
(
:SYSTem:COMMunicate:LAN:DHCP[:STATe]
)” should be set to "OFF".
• The three IP configuration modes cannot be set to "OFF" at the same time.
• After sending the command, execute
:SYSTem:COMMunicate:LAN:APPLy
to
apply the network parameters currently set.
Return Format
The query returns 1 or 0.
Command System
80
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
To Next Page
Loading...
