Rigol DP2000 Series Programming Guide

• PARallel: Queries the total voltage, current, and power of the present parallel
loop.
If <source> is omitted, the command queries the voltage, current, and power
measured at the output terminal of the channel currently selected.
Yo can also send :MEASure[:SCALar][:VOLTage]
[:DC]?
, :MEASure[:SCALar]:CURRent[:DC]? , and :MEASure[:SCALar]:POWEr[:DC]? to
query the voltage, current, and power measured at the output terminal of the
specified channel respectively.
Return Format
The query returns the voltage, current, and power (separated by commas) measured
at the output terminal of the specified channel. For example, the query might return
2.0000,0.0500,0.100.
Examples
:MEAS:ALL? CH1 /*Queries the voltage, current, and power measured
at the output terminal of CH1. The query returns
2.0000,0.0500,0.100.*/
4.6.2 :MEASure[:SCALar]:CURRent[:DC]?
Syntax
:MEASure[:SCALar]:CURRent[:DC]? [< source >]
Description
Queries the current measured at the output terminal of the specified channel.
Parameter
Name
Type Range Default
<source> Discrete
{CH1|CH2|CH3|ALL|SERies|
PARallel}
-
Remarks
• SERies: Queries the total current of the present series loop.
• PARallel: Queries the total current of the present parallel loop.
If <source> is omitted, the command queries the current measured at the output
terminal of the specified channel.
You can also send
:MEASure[:SCALar]:ALL[:DC]? to query the voltage, current, and
power measured at the output terminal of the specified channel at the same time.
Command System
36
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.

Rigol DP2000 Series Specifications

General

Brand	Rigol
Model	DP2000 Series
Category	Power Supply
Language	English