Return Format
The query returns the the current measured at the output terminal of the specified
channel, for example, 0.0500.
Examples
:MEAS:CURR? CH1 /*Queries the current measured at the output
terminal of CH1. The query returns 0.0500.*/
4.6.3 :MEASure[:SCALar]:POWEr[:DC]?
Syntax
:MEASure[:SCALar]:POWEr[:DC]? [<
source
>]
Description
Queries the power measured at the output terminal of the specified channel.
Parameter
Name
Type Range Default
<source> Discrete
{CH1|CH2|CH3|ALL|SERies|
PARallel}
-
Remarks
• SERies: Queries the total power of the present series loop.
• PARallel: Queries the total power of the present parallel loop.
If <source> is omitted, the command queries the power measured at the output
terminal of the channel currently selected.
You can also send
:MEASure[:SCALar]:ALL[:DC]?
to query the voltage, current, and
power measured at the output terminal of the specified channel at the same time.
Return Format
The query returns the power measured on the output terminal of the specified
channel, for example, 0.100.
Examples
:MEAS:POWE? CH1 /*Queries the power measured on the output terminal
of CH1. The query returns 0.100.*/
4.6.4 :MEASure[:SCALar][:VOLTage][:DC]?
Syntax
:MEASure[:SCALar][:VOLTage][:DC]? [<
source
>]
Command System
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
37
To Next Page
Loading...
Need help?
General
