Rigol DSA832E - Mmemory:load:limit; Mmemory:load:mtable

RIGOL Chapter 2 Command System
2-80 DSA800E Programming Guide
:MMEMory:LOAD:LIMit
Syntax
:MMEMory:LOAD:LIMit <file_name>
Description
Load the edited limit line file (.lim) into the instrument.
Parameter
Name
Type
Range
Default
<file_name>
ASCII String
--
--
Explanation
<file_name> should contain the path and the filename.
This operation fails when the specified file does not exist.
Example
The command below loads the limit line file upp1.lim in the D disk into the instrument.
:MMEM:LOAD:LIM D:\Limit1:upp1.lim
:MMEMory:LOAD:MTABle
Syntax
:MMEMory:LOAD:MTABle <file_name>
Description
Load the stored marker table file (.mkr) into the instrument.
Parameter
Name
Type
Range
Default
<file_name>
ASCII String
--
--
Explanation
<file_name> should contain the path and the filename.
The marker table file can only be stored in external memory and can only be loaded into the instrument
from external memory.
This operation fails if the specified file does not exist.
Example
The command below loads the marker table file Mark.mkr in the USB storage device into the instrument.
:MMEMory:LOAD:MTABle E:\Mak.mkr