EasyManua.ls Logo

Rigol DSA832E

Rigol DSA832E
243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-133
Example
The command below sets the average mode to repeat average.
:SENSe:HDISt:AVERage:TCONtrol REPeat
The query below returns REP.
:SENSe:HDISt:AVERage:TCONtrol?
[:SENSe]:HDISt:NUMBers
Syntax
[:SENSe]:HDISt:NUMBers <integer>
[:SENSe]:HDISt:NUMBers?
Description
Set the number of the harmonics to be measured.
Query the number of the harmonics to be measured.
Parameter
Name
Type
Range
Default
<integer>
Integer
2 to 10
10
Explanation
This command is only available when the harmonic distortion measurement is enabled.
Return Format
The query returns the number of harmonics in integer.
Example
The command below sets the number of harmonics to 5.
:SENSe:HDISt:NUMBers 5
The query below returns 5.
:SENSe:HDISt:NUMBers?

Table of Contents

Other manuals for Rigol DSA832E

Related product manuals