Rigol DSA832E

RIGOL Chapter 2 Command System
2-76 DSA800E Programming Guide
:INITiate[:IMMediate]
Syntax
:INITiate[:IMMediate]
Description
In non-measurement state, initialize a sweep.
In measurement state, trigger a measurement.
Explanation
The instrument must be in single measurement mode. This command will be ignored if
the
:INITiate:CONTinuous command is set to ON or 1.
Use the
:FETCh? command to transmit a measurement result from the internal memory to the output
buffer.
:INITiate:PAUSe
Syntax
:INITiate:PAUSe
Description
Switch the measurement state of the instrument from "Wait for Trigger" to "Pause".
Explanation
This command is only available when the measurement function is enabled and continuous measurement
mode is selected.
:INITiate:RESTart
Syntax
:INITiate:RESTart
Description
Restart the current measurement when the instrument is in idle state.
Explanation
This command is only available when the measurement function is enabled.
:INITiate:RESume
Syntax
:INITiate:RESume
Description
Restore the measurement state of the instrument from "Pause" to "Wait for Trigger".
Explanation
This command is only available when the measurement function is enabled and continuous measurement
mode is selected.