Rigol DSA832E

Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-37
:CONFigure:CHPower
Syntax
:CONFigure:CHPower
Description
Set the spectrum analyzer to the channel power measurement state.
Explanation
This command stops the current measurement and sets the instrument to the default state of the specified
measurement.
When any of the measurement settings is changed, use the
:READ command to initialize the measurement
without restoring it to the default value.
:CONFigure:CNRatio
Syntax
:CONFigure:CNRatio
Description
Set the spectrum analyzer to the C/N ratio measurement state.
Explanation
This command stops the current measurement and sets the instrument to the default state of the specified
measurement.
When any of the measurement settings is changed, use the
:READ command to initialize the measurement
without restoring it to the default value.
:CONFigure:EBWidth
Syntax
:CONFigure:EBWidth
Description
Set the spectrum analyzer to the emission bandwidth measurement state.
Explanation
This command stops the current measurement and sets the instrument to the default state of the specified
measurement.
When any of the measurement settings is changed, use the
:READ command to initialize the measurement
without restoring it to the default value.