Rigol DSA832E

Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-165
:SYSTem:COMMunicate:LAN[:SELF]:MANuip:STATe
Syntax
:SYSTem:COMMunicate:LAN[:SELF]:MANuip:STATe OFF|ON|0|1
:SYSTem:COMMunicate:LAN[:SELF]:MANuip:STATe?
Description
Enable or disable the manual IP setting mode.
Query the status of the manual IP setting mode.
Parameter
Name
Type
Range
Default
--
Bool
OFF|ON|0|1
OFF|0
Explanation
The spectrum analyzer always tries to get the IP address configuration in the order of DHCP, auto IP and
manual IP. The three setting modes cannot be turned off at the same time.
Return Format
The query returns 0 or 1.
Example
The command below enables the manual IP setting mode.
:SYSTem:COMMunicate:LAN:SELF:MANuip:STATe ON
or :SYSTem:COMMunicate:LAN:SELF:MANuip:STATe 1
The query below returns 1.
:SYSTem:COMMunicate:LAN:SELF:MANuip:STATe?
:SYSTem:COMMunicate:LAN[:SELF]:RESet
Syntax
:SYSTem:COMMunicate:LAN[:SELF]:RESet
Description
Reset the LAN setting: enable the DHCP and Auto IP, disable the Manual IP.
:SYSTem:COMMunicate:USB[:SELF]:ADDRess?
Syntax
:SYSTem:COMMunicate:USB[:SELF]:ADDRess?
Description
Query the USB device address.
Return Format
The query returns the USB device address; for example, 1.