Rigol DSA832E

Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-115
[:SENSe]:CORRection:CSET:ALL:DELete
Syntax
[:SENSe]:CORRection:CSET:ALL:DELete
Description
Delete all the amplitude correction data.
[:SENSe]:CORRection:CSET:ALL[:STATe]
Syntax
[:SENSe]:CORRection:CSET:ALL[:STATe] OFF|ON|0|1
[:SENSe]:CORRection:CSET:ALL[:STATe]?
Description
Enable or disable the amplitude correction function.
Query the status of the amplitude correction function.
Parameter
Name
Type
Range
Default
--
Bool
OFF|ON|0|1
OFF|0
Explanation
When the function is enabled, all the correction settings are enabled and by default, Antenna correction is
used.
When the function is disabled, all the correction settings are disabled.
To enable or disable a single correction setting, refer to the [:SENSe]:CORRection:CSET<n>[:STATe]
command.
Return Format
The query returns 0 or 1.
Example
The comamnd below enables the amplitude correction function.
:SENSe:CORRection:CSET:ALL:STATe ON or :SENSe:CORRection:CSET:ALL:STATe 1
The query below returns 1.
:SENSe:CORRection:CSET:ALL:STATe?