Rigol DSA832E

RIGOL Chapter 2 Command System
2-38 DSA800E Programming Guide
:CONFigure:HDISt
Syntax
:CONFigure:HDISt
Description
Set the spectrum analyzer to the harmonic distortion measurement state.
Explanation
This command stops the current measurement and sets the instrument to the default state of the specified
measurement.
When any of the measurement settings is changed, use the
:READ command to initialize the measurement
without restoring it to the default value.
:CONFigure:OBWidth
Syntax
:CONFigure:OBWidth
Description
Set the spectrum analyzer to the occupied bandwidth measurement state.
Explanation
This command stops the current measurement and sets the instrument to the default state of the specified
measurement.
When any of the measurement settings is changed, use the
:READ command to initialize the measurement
without restoring it to the default value.
:CONFigure:PF
Syntax
:CONFigure:PF
Description
Enable the Pass/Fail test function.
:CONFigure:SANalyzer
Syntax
:CONFigure:SANalyzer
Description
This command will disable the current measurement function and set the spectrum analyzer to sweep
mode.