Rigol DSA832E

Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-89
:READ Subsystem
Both the :READ commands and the
:FETCh commands are used to acquire the measurement results. The
difference between them lies in that the
:FETCh commands acquire the measurement results immediately
while the :READ commands start a measurement and return the measurement results after the
measurement finishes.
Command List:
 :READ:ACPower?
 :READ:ACPower:LOWer?
 :READ:ACPower:MAIN?
 :READ:ACPower:UPPer?
 :READ:CHPower?
 :READ:CHPower:CHPower?
 :READ:CHPower:DENSity?
 :READ:CNRatio?
 :READ:CNRatio:CARRier?
 :READ:CNRatio:CNRatio?
 :READ:CNRatio:NOISe?
 :READ:EBWidth?
 :READ:HARMonics:AMPLitude:ALL?
 :READ:HARMonics:AMPLitude? <n>
 :READ:HARMonics[:DISTortion]?
 :READ:HARMonics:FREQuency:ALL?
 :READ:HARMonics:FREQuency? <n>
 :READ:HARMonics:FUNDamental?
 :READ:OBWidth?
 :READ:OBWidth:OBWidth?
 :READ:OBWidth:OBWidth:FERRor?
 :READ:TOIntercept?
 :READ:TOIntercept:IP3?
 :READ:TPOWer?
Explanation:
The :READ commands are only available for DSA800E installed with the advanced measurement kit
(option).