Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-1
Chapter 2 Command System
In this chapter, the DSA800E series spectrum analyzer command subsystems are introduced in alphabetical
order (from A to Z).
Main topics of this chapter:
:ABORt
:CALCulate Subsystem
:CALibration Subsystem
:CONFigure Subsystem
:COUPle Subsystem
:DISPlay Subsystem
:FETCh Subsystem
:FORMat Subsystem
:HCOPy Subsystem
IEEE 488.2 Common Commands
:INITiate Subsystem
:INPut Subsystem
:MMEMory Subsystem
:OUTPut Subsystem
:READ Subsystem
[:SENSe] Subsystem
:SOURce Subsystem
:STATus Subsystem
:SYSTem Subsystem
:TRACe Subsystem
:TRIGger Subsystem
:UNIT Subsystem
Explanation:
1. In this command set, commands relating to Quasi-peak detector, EMI filter, VSWR measurement,
advanced measurement and TX1000 are only applicable to DSA800E installed with the corresponding
options. For the details, refer to the explanation in each command subsystem.
2. In this command set, commands relating to the tracking generator are only applicable to DSA832E-TG.
3. In this command set, unless otherwise noted, the query returns "N/A" (quotation marks excluded) if
the corresponding option is not installed and returns "ERR" (quotation marks excluded) if the
corresponding function is not enabled or the type does not match.
To Next Page
Loading...
