Rigol DSA832E

Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-75
:INITiate Subsystem
Command List:
 :INITiate:CONTinuous
 :INITiate[:IMMediate]
 :INITiate:PAUSe
*
 :INITiate:RESTart*
 :INITiate:RESume*
Explanation:
Commands marked with "*" are only available for DSA800E installed with the advanced measurement kit
(option).
:INITiate:CONTinuous
Syntax
:INITiate:CONTinuous OFF|ON|0|1
:INITiate:CONTinuous?
Description
In non-measurement state, select continuous (ON|1) or single (OFF|0) sweep. In measurement state,
select continuous (ON|1) or single (OFF|0) measurement.
Query the sweep or measurement mode.
Parameter
Name
Type
Range
Default
--
Bool
OFF|ON|0|1
ON|1
Return Format
The query returns 0 or 1.
Example
The command below sets the instrument to sweep continuously (the instrument is in non-measurement
state).
:INITiate:CONTinuous ON or :INITiate:CONTinuous 1
The query below returns 1.
:INITiate:CONTinuous?