Rigol DSA832E Programming Guide

RIGOL Chapter 2 Command System
2-160 DSA800E Programming Guide
 :SYSTem:USERkey:KEYCmd
 :SYSTem:USERkey:STATe
 :SYSTem:VERSion?
Explanation:
Commands marked with "**" are only available for DSA800E installed with the RF Demo kit (option).
:SYSTem:BEEPer:STATe
Syntax
:SYSTem:BEEPer:STATe OFF|ON|0|1
:SYSTem:BEEPer:STATe?
Description
Enable or disable the beeper in Pass/Fail test.
Query the status of the beeper.
Parameter
Name
Type
Range
Default
--
Bool
OFF|ON|0|1
OFF|0
Return Format
The query returns 0 or 1.
Example
The command below enables the beeper.
:SYSTem:BEEPer:STATe ON or :SYSTem:BEEPer:STATe 1
The query below returns 1.
:SYSTem:BEEPer:STATe?
:SYSTem:CLEar
Syntax
:SYSTem:CLEar
Description
Clear all the data of user settings.
Explanation
After clearing the user data, restore the settings to the factory state, including:
— Restore the user data stored in NVRAM and NorFlash to factory settings.
— restore the HOST NAME, IP address and password in the LXI to factory settings.

Rigol DSA832E Specifications

General

Brand	Rigol
Model	DSA832E
Category	Measuring Instruments
Language	English