Rigol DSA832E

Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-101
 [:SENSe]:POWer[:RF]:GAIN[:STATe]
 [:SENSe]:POWer[:RF]:MIXer:RANGe[:UPPer]
 [:SENSe]:SWEep:COUNt
 [:SENSe]:SWEep:COUNt:CURRent?
 [:SENSe]:SWEep:POINts
 [:SENSe]:SWEep:TIME
 [:SENSe]:SWEep:TIME:AUTO
 [:SENSe]:SWEep:TIME:AUTO:RULes
 [:SENSe]:TOI:AVERage:COUNt
*
 [:SENSe]:TOI:AVERage[:STATe]*
 [:SENSe]:TOI:AVERage:TCONtrol*
 [:SENSe]:TOI:FREQuency:SPAN*
 [:SENSe]:TPOWer:AVERage:COUNt*
 [:SENSe]:TPOWer:AVERage[:STATe]*
 [:SENSe]:TPOWer:AVERage:TCONtrol*
 [:SENSe]:TPOWer:LLIMit*
 [:SENSe]:TPOWer:MODE*
 [:SENSe]:TPOWer:RLIMit*
 [:SENSe]:VSWR:FREFlect**
 [:SENSe]:VSWR:NREFlect**
 [:SENSe]:VSWR:RESet**
 [:SENSe]:VSWR:STATe**
Explanation:
Commands marked with "*" are only available for DSA800E installed with the advanced measurement kit
(option) and those marked with "**" are only available for DSA800E installed with the VSWR measurement
kit (option).