Rigol DSA832E - Page 25

Chapter 2 Command System RIGOL
DSA800E Programming Guide 2-3
 :CALCulate:MARKer<n>:PEAK:EXCursion
 :CALCulate:MARKer<n>:PEAK:SEARch:MODE
 :CALCulate:MARKer<n>:PEAK[:SET]:CF
 :CALCulate:MARKer<n>:PEAK:THReshold
 :CALCulate:MARKer<n>:PTPeak
 :CALCulate:MARKer<n>[:SET]:CENTer
 :CALCulate:MARKer<n>[:SET]:RLEVel
 :CALCulate:MARKer<n>[:SET]:STARt
 :CALCulate:MARKer<n>[:SET]:STEP
 :CALCulate:MARKer<n>[:SET]:STOP
 :CALCulate:MARKer<n>:STATe
 :CALCulate:MARKer<n>:TRACe
 :CALCulate:MARKer<n>:TRACe:AUTO
 :CALCulate:MARKer<n>:VSRefl?
*
 :CALCulate:MARKer<n>:VSValue?*
 :CALCulate:MARKer<n>:X
 :CALCulate:MARKer<n>:X:CENTer
 :CALCulate:MARKer<n>:X:POSition
 :CALCulate:MARKer<n>:X:POSition:CENTer
 :CALCulate:MARKer<n>:X:POSition:SPAN
 :CALCulate:MARKer<n>:X:POSition:STARt
 :CALCulate:MARKer<n>:X:POSition:STOP
 :CALCulate:MARKer<n>:X:READout
 :CALCulate:MARKer<n>:X:SPAN
 :CALCulate:MARKer<n>:X:STARt
 :CALCulate:MARKer<n>:X:STOP
 :CALCulate:MARKer<n>:Y?
 :CALCulate:MARKer:TABLe:STATe
 :CALCulate:MARKer:TRACking:STATe
 :CALCulate:NTData[:STATe]
Explanation:
Commands marked with "*" are only available for DSA800E installed with the VSWR measurement kit
(option).