GX-6000 Operator’s Manual Using Maintenance Mode • 146
7 . The appearance of the password screen will be affected by Maintenance
Mode’s PASSWORD setting.
8 . If Maintenance Mode’s
PASSWORD is set to OFF, continue to Step 11.
9 . If Maintenance Mode’s
PASSWORD is set to ON (factory setting),
enter the password by using the ▲AIR and SHIFT ▼ (PANIC) buttons to
select each password number and then pressing and releasing the
POWER/ENTER button to enter it and move on to the next number until
all of the numbers are entered. The password is 0006.
10 . If you enter an incorrect password, an error screen will appear.
You must turn the unit off and reenter Maintenance Mode using the
correct password. Continue to Step 12.
11 . If Maintenance Mode’s
PASSWORD is set to OFF, press and release
the POWER/ENTER button to enter Maintenance Mode. There is no
need to enter a password. The password screen appears even if
PASSWORD is set to OFF so that a special factory mode can be
accessed, if necessary.
PASSWORD
INPUT
PASSWORD
0 0 0 0
Maint. PASSWORD set to ON Maint. PASSWORD set to OFF
4:07
INPUT
PASSWORD
- - - -
ENTER FOR
MAINTENANCE MODE
To Next Page
Loading...
