Roche cobas b 123 - Page 349

Roche Diagnostics
Instructions for Use · Version 13.0 349
cobas b 123 POC system Index
Index
Numerics
1P calibration, 225
2P calibration, 225
A
Abbreviations, 10
Accessories
– Instrument, 30
– Sample collection containers, 142
Acid base map, 176
Action buttons, 247
Alarm area and buttons, 314
AMR
– Configuration, 241
Anticoagulants, 140
Assigning a correlation factor to a parameter, 122
Assigning reference and critical ranges, 118
Assigning unit formats to parameters, 95
Audit trail, 286
Automatic calibrations
– 1P calibration, 225
– 2P calibration, 225
– Monitoring, 226
– Oximeter calibration, 226
– PO2 calibration, 225, 226
– Standby calibration, 226
– Standby shifting, 226
– System calibration, 225
– Wash cycle, 227
AutoQC measurements, 184
AutoQC Pack, 49
– Consumable change, 305
– Types, 50
Available accessories and consumables, 333
– Accessories, 336
– Fluid Pack, 335
– QC materials, 336
– Sensor Cartridge, 335
Available printout reports, 288
– Acid base report, 288
– Levey-Jennings report, 292
– Measurement report, 288
– Patient trending report, 289
– Proficiency test report, 290
– QC report, 291
– Sensor status report, 293
B
Barcode scanner, 38
– Specifications, 90
– Troubleshooting, 328
Barcode scanner assignments, 36
C
Calibration, 221
– 1P calibration, 225
– 2P calibration, 225
– Automatic calibrations, 225
– Calibration database, 229
– Calibration for "Ready", 228
– Calibration intervals, 83
– Calibration principle, 113
– Calibration schemes, 223
– Configuring calibration settings, 230
– General information, 223
– Oximeter calibration, 226
– PO2 calibration, 225
– Recalibration, 226
– Standby calibration, 226
– Standby shifting, 226
– System calibration, 225
– User-activated calibrations, 228
Calibration database, 229
Calibration for "Ready", 228
Calibration principle, 113
Calibration schemes, 223
Calibration troubleshooting for parameters, 324
Calibration verification control, 233
– AutoCVC measurements, 238
– Configuring AMRs, 241
– CVC results in the QC database, 240
– General information, 235
– Installing AutoCVC Packs, 236
Capillary tubes, 142
Changing printer paper, 306
Checking Fluid Pack valve positions, 327
Clot Catcher, 142
Clot Catcher PRO, 143
Comparison of micro samples to normal samples, 78
Configuring AMRs, 241
– Adding new AMRs, 241
– Editing new AMRs, 242
Configuring calibration settings, 230
– Activating automatic printing of calibration reports,
231
– Defining daily frequency of 2P calibrations, 231
– Defining start times for system calibrations, 230
Configuring measurement input values, 154
Configuring network connection settings, 269
– Activating cobas e-support, 275