Roland Fantom XR - Dividing a Sample During Sampling

119
Sampling
8. If Stop Trigger is set to MANUAL, press [SAMPLING] to stop
sampling.
The Sample Edit (p. 122) screen will appear.
* If you want to edit the sample, refer to p. 120.
fig.14-007
When you finish sampling, the sample will automatically be
added to the sample list. You can view the sample list by
pressing [SHIFT] so it lights and then pressing .
Samples you record will be lost when you turn off the
power. If you want to keep your sample, be sure to save the
sample (p. 131). Samples shown as “N” in the sample list have
not yet been saved.
fig.14-008
9. Press [EXIT] to go back to the previous screen.
1. During sampling, press [ENTER].
The sample will be divided at the point where you pressed the
button, and the subsequent material will be sampled as a
sample of the next number.
* When sampling in mono, you can divide the material into a maximum
of 256 samples. When sampling in stereo, you can divide the material
into a maximum of 128 samples (L/R total 256 samples).
Sampling time
The Fantom-XR contains 16 MB of memory, which allows about
180 seconds of mono or about 90 seconds of stereo sampling. If
you want to sample for a longer time than this, you must install
separately sold memory (DIMM) (p. 170, p. 172).
Dividing a Sample During
Sampling
Fantom-XR_r_e.book 119 ページ ２００６年４月４日 火曜日 午前１０時１４分