15
Panel Descriptions
N
[MODE]
Switches between Patch mode and Performance mode.
[GROUP]
Switches the patch group or other group. To switch the group, hold
down this button and turn the VALUE dial, or use [INC][DEC].
[FX]
Make effect-related settings. Here you can also make mastering
settings. -> (p. 132)
[ARP]
Make settings for arpeggios, chord memory, and rhythm. -> (
p. 97
.
p.
104
,
p. 107
)
Tone switches [1]–[4]
To switch Tones 1–4 on/off, hold down [SHIFT] and press these
buttons. -> (p. 47)
O
[DEC], [INC]
This is used to modify values. If you keep on holding down one
button while pressing the other, the value change accelerates.
P
[SHIFT]
This button is used in conjunction with other buttons to execute
various functions.
When you press [SHIFT], the button will light, and other buttons
will then offer an alternate set of functions. To return to the original
functions, press this button once again and extinguish the indicator.
Q
[MENU]
Opens the MENU. The contents of the menu will depend on the
current mode.
fig.01-002
R
AC Inlet
Connect the included power cord to this inlet. -> (p. 17)
* For details on the power consumption, refer to p. 272.
The unit should be connected to a power source only of the
type marked on the bottom of the unit.
S
DIGITAL IN/OUT Connectors
These are coaxial-type digital in/out connectors.
These connectors input and output a digital audio signal (stereo).
The output signal is identical to the signal that is output from the
OUTPUT A (MIX) jacks.
T
MIDI Connectors (IN, OUT, THRU)
These connectors can be connected to other MIDI devices to receive
and transmit MIDI messages.
U
OUTPUT B Jacks (L, R)
These jacks output the audio signal to the connected mixer/amplifier
system in stereo.
V
OUTPUT A (MIX) Jacks (L (MONO), R)
These jacks output the audio signal to the connected mixer/amplifier
system in stereo. For mono output, use the L jack. -> (p. 16)
INDIVIDUAL 1–4 Jacks
These jacks output audio signals in mono to an amp or mixer.
* The setting determining whether these jacks are used as stereo
OUTPUT jacks or monaural INDIVIDUAL jacks is made with the
Output Assign setting (p. 134, p. 140).
W
INPUT (Audio Input) Jack (L, R)
Accept input of audio signals in stereo (L/R) from external devices.
If you want to use mono input, connect to the L jack.
When recording from a mic, connect it to the L jack, and set Input
Select (p. 115) to “MICROPHONE.”
X
USB Connector
This connector lets you use a USB cable to connect your computer to
the Fantom-XR. -> (p. 148)
Rear Panel
Fantom-XR_r_e.book 15 ページ ２００６年４月４日 火曜日 午前１０時１４分
To Next Page
Loading...
