167
Installing the Wave Expansion Board
4.
Use the Installation Tool supplied with the Wave Expansion
Board to turn the holders in the LOCK direction, so the
board will be fastened in place.
fig.30-006.e
5.
Use the screws that you removed in step 2 to fasten the
cover back in place.
After installation of the Wave Expansion Boards has been
completed, check to confirm that the installed boards are being
recognized correctly.
1.
Turn on the power, as described in “Turning On the Power”
(p. 17).
2.
Press [MENU].
The Top Menu screen will appear.
3.
Press or to select “System.”
4.
Press [ENTER].
5.
Press or to display System SRX Info screen.
The System screen will appear. Verify that the name of the
installed Wave Expansion Board is displayed.
fig.30-007_50
If “----------” appears next to the installed slot name, it’s possible
that the installed Wave Expansion Board is not being
recognized correctly. Re-install the Wave Expansion Board
correctly.
6.
Press [EXIT] to exit the System screen.
Installation tool
LOCK
Checking the Installed Wave
Expansion Boards
Fantom-XR_r_e.book 167 ページ ２００６年４月４日 火曜日 午前１０時１４分
To Next Page
Loading...
