Roland Fantom XR - Choosing Patches

24
Playing Sounds
1. Press [MODE] so the button lights in red.
You will enter Patch mode, and the Patch Play screen will appear.
2. Press or to move the cursor to the patch number.
fig.03-006a.e
3. Turn the VALUE dial or use [INC][DEC] to select the patch.
1. Press [MODE] so the button lights in red.
You will enter Patch mode, and the Patch Play screen will appear.
2. Press [GROUP] to select the patch group.
The group changes as shown below.
USER (User) -> PR-A (Preset A) -> . . . -> PR-H (Preset H) -> GM (General MIDI) ->
Card (Memory Card) -> XP-A (Expansion A) -> . . . -> XP-F (Expansion F)
fig.03-007.e
Alternatively, press [CURSOR] to move the cursor to the patch group, and turn the VALUE dial
or use [INC][DEC] to select the patch group.
Choosing a Patch
Basic Procedure for Choosing a Patch
Choosing a Group
fig.03-006
2
33
1
Patch number
The value will change more
rapidly if you turn the dial
while holding down [VALUE].
Patch group
XP-A through XP-F appear
only if the corresponding
expansion board is installed.
“Bank Select and Program
Change Correspondence
Chart” (p. 270)
Fantom-XR_r_e.book 24 ページ ２００６年４月４日 火曜日 午前１０時１４分