155
Settings Common to All Modes (System Function)
Settings that affect the entire operating environment of the Fantom-
XR, such as tuning and MIDI message reception, are referred to as
system functions.
This section explains how to make settings for
the System functions and describes the functions of the different
System parameters.
1.
In the Patch Play screen (p. 40) or the Performance Play
screen (p. 84), press [MENU].
The Top Menu screen will appear.
2.
Press or to select “System.”
3.
Press [ENTER].
The System Setup screen will appear.
fig.25-001
4.
The parameters are organized into several edit groups. Use
or to switch the groups.
5.
Press or to move the cursor to the parameter you
want to edit.
6.
Turn the VALUE dial or use [INC][DEC] to set the value.
7.
Repeat steps 4–6 to set each System parameter you want to
edit.
Changes you make to the System function settings are only
temporary—they will be discarded as soon as the power is turned
off. If you want to keep any changes you’ve made in the system
settings, you must save them in internal system memory.
When you perform the save procedure, the data that previously
occupied the save destination will be lost. However, the factory
setting data can be recovered by performing the Factory Reset
procedure.
1.
After editing the System settings in the various screens,
press [SHIFT] so it lights, and then press .
A message will ask you confirmation.
2.
To save the settings, press [ENTER].
* To cancel, press [EXIT].
fig.25-002
The display will indicate “System Write Completed!” The data
will be saved, and you’re returned to the System Setup screen.
How to Make System
Function Settings
Saving the System Settings
(Write)
Fantom-XR_r_e.book 155 ページ ２００６年４月４日 火曜日 午前１０時１４分
To Next Page
Loading...
