Roland Fantom XR - Getting Ready; Connecting Audio Equipment

16
Getting Ready
Since the Fantom-XR contains no amplifier or speakers, you’ll need to connect it to audio
equipment such as a keyboard amplifier, monitor speaker system or home stereo, or use
headphones to hear its sound.
1. Before hooking anything up, make sure that the power on all of your gear is turned
OFF.
2. Connect one end of the supplied power cable to the Fantom-XR, and the other end to a
power outlet.
3. Connect the Fantom-XR to your amp/speaker system as shown in the diagram.
fig.02-002.e
Connecting an Amp and Speaker System
921
To prevent malfunction and/
or damage to speakers or other
devices, always turn down the
volume, and turn off the
power on all devices before
making any connections.
MIDI IN
MIDI OUT
Mixer etc.
Power amp
Monitor speakers
(powered)
Stereo headphones
External MIDI device
(MIDI Keyboard, Sequencer, etc.)
to Power outlet
In order to fully experience the
Fantom-XR’s sound, we
recommend using a stereo
amp/speaker system. If you’re
using a mono system,
however, make your
connections to the Fantom-
XR’s OUTPUT A (MIX) jack L
(MONO).
Audio cables are not included
with the Fantom-XR. You’ll
need to provide them.
For details on how to install a
Wave Expansion Board (sold
separately), refer to “Installing
the Wave Expansion Board”
(p. 166).
Fantom-XR_r_e.book 16 ページ ２００６年４月４日 火曜日 午前１０時１４分