Roland Fantom XR - Initializing Patch Settings (Init); Copying Patch (Tone) Settings (Copy); Saving Patches Youve Created (Write)

69
Creating a Patch
“Initialize” means to return the settings of the currently selected
sound to a standard set of values.
The Initialize operation will affect only the currently selected
sound; the sounds that are stored in user memory will not be
affected. If you wish to restore all of the Fantom-XR’s settings to
their factory values, perform a Factory Reset (p. 162).
1. In the Patch Edit Menu screen, press [MENU].
The Patch Utility screen will appear.
2. Use or to select “Initialize.”
fig.06-060
3. Press [ENTER].
A message will ask you for confirmation.
4. Press [ENTER].
The initialization will be carried out, and you’ll be returned to
the previous screen.
To cancel, press [EXIT].
This operation copies the settings of any desired patch to the
currently selected patch. You can use this feature to make the editing
process faster and easier.
1. In the Patch Play screen, select the copy-destination
patch (p. 40).
2. In the Patch Edit Menu screen, press [MENU].
The Patch Utility screen will appear.
3. Use or to select “Tone Copy.”
4. Press [ENTER].
The Patch Tone Copy screen will appear.
fig.06-061
5. Press [CURSOR] to move the cursor, select the “Source
(copy-source)” group and number, and patch tone.
fig.06-062
At this time you can press the OUTPUT knob to audition the
copy-source patch for comparison (the Compare function).
* The patch auditioned using the Compare function may sound slightly
different than when it is played normally.
6. Turn the VALUE dial or use [INC][DEC] to make settings.
7. Press [CURSOR] to move the cursor, select the
“Destination (copy-destination)” patch tone number.
8. Turn the VALUE dial or use [INC][DEC] to make settings.
9. Press [ENTER].
A message will ask you for confirmation.
10. Press [ENTER].
You’ll be returned to the Patch Edit Menu screen.
To cancel, press [EXIT].
Changes you make to sound settings are temporary, and will be lost
if you turn off the power or select another sound. If you want to keep
the modified sound, you must save it in the internal USER group
(user memory) or the memory card.
If you edit the settings of a patch, the indication “E” is displayed in
the upper right of the Patch Play screen. This “E” indication
disappears when you save the patch to the Fantom-XR’s internal
user memory or to the memory card.
When you perform the save procedure, the data that previously
occupied the save destination will be lost.
1. Make sure that the patch you wish to save is selected.
2. Press [SHIFT] so it lights, and then press .
The Patch Name screen will appear.
fig.06-063
3. Assign a name to the patch.
For details on assigning names, refer to “Assigning a Name”
(p. 39)
Initializing Patch Settings
(Init)
Copying Patch (Tone)
Settings (Copy)
Saving Patches You’ve
Created (Write)
Fantom-XR_r_e.book 69 ページ ２００６年４月４日 火曜日 午前１０時１４分