161
Settings Common to All Modes (System Function)
System Sampling
Parameter
Value Description
Default File Type
WAV, AIFF
Specifies the file format used when saving a sample.
Pre Sample Time
0–1000 ms
The length of sound preceding the moment at which sampling was manually
or automatically initiated that will be captured in the sample. This lets you
prevent the attack portion of the sound from being omitted from the sample.
Trigger Level
0–7
Volume level at which sampling will begin when Auto Trig is ON
A setting of 0 is the minimum.
Gap Time
500, 1000, 1500, 2000
ms
Length of silence at which the sample will be divided
Whenever there is a silent region longer than the specified time, the sample will be
divided at that point, and the next sample number will be assigned to the sound that
follows. This parameter is valid only when you are using Auto Divide Sampling.
Input Select
DIGITAL IN,
LINE-L/R,
LINE-L,
MICROPHONE
Input source of the external input sound
DIGITAL IN:
DIGITAL INPUT jack
LINE-L/R:
INPUT jacks L/R (stereo)
LINE-L:
INPUT jack L (mono)
MICROPHONE:
INPUT jack (mono, mic level)
Trimming Switch
OFF, ON
If this is turned on, the Start point and End point settings will be
automatically adjusted after sampling is performed, so any silent portions at
the beginning or end of the sampled sound are excluded.
System Memory Info
Displays the amount of memory installed.
System SRX Info
Displays the name of the wave expansion board that is installed.
System Version Info
Displays the version of the Fantom-XR.
Fantom-XR_r_e.book 161 ページ ２００６年４月４日 火曜日 午前１０時１４分
To Next Page
Loading...
