137
Adding Effects
Reverb Output
fig.22-023a
Reverb Output Level
Adjusts the volume of the sound that has passed through
reverb.
Value:
0–127
Reverb Output Assign
Specifies how the sound routed through reverb will be output.
Value
A:
Output to the OUTPUT A (MIX) jacks in stereo.
B:
Output to the OUTPUT B jacks in stereo.
If the Mix/Parallel parameter is set to “MIX,” all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 158).
Mastering Effect
fig.22-030
Mastering effect settings apply to the entire Fantom-XR. These
settings are not for individual patches or performances.
For details on the Mastering Effect, refer to
“Mastering Effects”
(p.
146).
MFX Control
To access the MFX Control screen
1.
From the Effect Edit Menu screen, turn the VALUE dial or
use [INC][DEC] to select “CTRL.”
fig.22-0052
2.
Press [ENTER].
Control 1–4 Src (Multi-Effects Control Source 1–4)
Sets the MIDI message used to change the multi-effects parameter
with the multi-effects control.
Value
OFF:
Multi-effects control will not be used.
CC01–31, 33–95:
Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to
“MIDI Implementation”
(p. 245).
PITCH BEND:
Pitch Bend
AFTERTOUCH:
Aftertouch
SYS CTRL1–SYS CTRL4:
MIDI messages used as common multi-
effects controls.
16
17
Fantom-XR_r_e.book 137 ページ ２００６年４月４日 火曜日 午前１０時１４分
To Next Page
Loading...
