199
Effects List
20: SLICER
 
By applying successive cuts to the sound, this effect turns a 
conventional sound into a sound that appears to be played as a 
backing phrase. This is especially effective when applied to sustain-
type sounds.
 
fig.MFX-20
 
You can use multi-effect control to make the step sequence play 
again from the beginning (p. 215).
 
21: ROTARY
 
The Rotary effect simulates the sound of the rotary speakers often 
used with the electric organs of the past. Since the movement of the 
high range and low range rotors can be set independently, the 
unique type of modulation characteristic of these speakers can be 
simulated quite closely. This effect is most suitable for electric organ 
Patches.
 
fig.MFX-21
 
22: VK ROTARY
 
This type provides modified response for the rotary speaker, with 
the low end boosted further.
This effect features the same specifications as the VK-7’s built-in 
rotary speaker.
 
fig.MFX-22
 
Parameter
Value Description
 
Step 01–16 
L64–63R Level at each step
Rate # 0.05–10.00 Hz, 
note
Rate at which the 16-step sequence will cy-
cle
Attack # 0–127 Speed at which the level changes between 
steps
Input Sync Sw OFF, ON Specifies whether an input note will cause 
the sequence to resume from the first step 
of the sequence (ON) or not (OFF)
Input Sync 
Threshold
0–127 Volume at which an input note will be de-
tected
Mode LEGATO, 
SLASH
Sets the manner in which the volume 
changes as one step progresses to the next.
 
LEGATO:
 
 The change in volume from 
one step’s level to the next remains unal-
tered. If the level of a following step is 
the same as the one preceding it, there is 
no change in volume.
 
SLASH:
 
 The level is momentarily set to 
0 before progressing to the level of the 
next step. This change in volume occurs 
even if the level of the following step is 
the same as the preceding step.
Shuffle # 0–127 Timing of volume changes in levels for 
even-numbered steps (step 2, step 4, step 
6...).
The higher the value, the later the beat 
progresses.
Level 0–127 Output level
 
Parameter
Value Description
 
Speed #
SLOW, FAST Simultaneously switch the rota-
tional speed of the low frequency 
rotor and high frequency rotor.
 
SLOW:
 
 Slows down the rota-
tion to the Slow Rate. 
 
FAST:
 
 Speeds up the rotation to 
the Fast Rate.
Wf Slow Speed 0.05–10.00 Hz Slow speed (SLOW) of the low fre-
quency rotor
L in
R in
L out
R out
Slicer
Slicer
Rotary
L out
R out
L in
R in
 
Wf Fast Speed
0.05–10.00 Hz Fast speed (FAST) of the low fre-
quency rotor
Wf Acceleration 0–15 Adjusts the time it takes the low 
frequency rotor to reach the newly 
selected speed when switching 
from fast to slow (or slow to fast) 
speed. Lower values will require 
longer times.
Wf Level 0–127 Volume of the low frequency rotor
Tw Slow Speed 0.05–10.00 Hz Settings of the high frequency ro-
tor
The parameters are the same as 
for the low frequency rotor
Tw Fast Speed 0.05–10.00 Hz
Tw Acceleration 0–15
Tw Level 0–127
Separation 0–127 Spatial dispersion of the sound
Level # 0–127 Output Level
 
Parameter
Value Description
 
Speed # SLOW, FAST Rotational speed of the rotating 
speaker
Brake # OFF, ON Switches the rotation of the rota-
ry speaker.
When this is turned on, the 
rotation will gradually stop. 
When it is turned off, the ro-
tation will gradually resume.
Wf Slow Speed 0.05–10.00 Hz Low-speed rotation speed of the 
woofer
Wf Fast Speed 0.05–10.00 Hz High-speed rotation speed of 
the woofer
Wf Trans Up 0–127 Adjusts the rate at which the 
woofer rotation speeds up when 
the rotation is switched from 
Slow to Fast.
Wf Trans Down 0–127 Adjusts the rate at which the 
woofer rotation speeds up when 
the rotation is switched from 
Fast to Slow.
Wf Level 0–127 Volume of the woofer
Tw Slow Speed 0.05–10.00 Hz Settings of the tweeter
The parameters are the same 
as for the woofer.
Tw Fast Speed 0.05–10.00 Hz
Tw Trans Up 0–127
Tw Trans Down 0–127
Tw Level 0–127
Spread 0–10 Sets the rotary speaker stereo 
image. The higher the value set, 
the wider the sound is spread 
out.
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Level # 0–127 Output Level
 
Parameter
Value Description
L out
R out
L in
R in
Rotary
2-Band EQ
2-Band EQ
Fantom-XR_r_e.book 199 ページ 2006年4月4日 火曜日 午前10時14分