132 Menu System Description ODIN Intercom Matrix
Packet Size Field
The Packet Size field is used to select the size of each audio packet. The packet size depends on the codec selected.
Available options for G.711a, G.711, G.722 – 10ms, 20ms, and 30ms; G.729A – 10ms, 20ms, 40ms, and 60ms.
Channel Field
The Channel field is used to select the channel number on the device to which this port is connected.
VA D F i e l d
The VAD field is used to select the threshold at which point audio is transmitted across the network.
The range for this field is -60dBm to -30 dBm, or Off.
Description Field
The Description field is used to enter a description for the channel.
2-Wire Ports
Frame Field
The Frame field is used to select the frame to be viewed.
2W Field
The 2W field displays the two 2-Wire channels (CH A and CH B)
Port Field
The Port field displays the port and alpha assigned to the 2W channel, if any.
This field is not editable.
NOTE: Use the “Port Allocation Table” on page 125 to reconfigure a 2W channel to a different intercom port.
FIGURE 64. Configuration | Ports | 2-Wire Ports
To Next Page
Loading...
