20 Basic Operation ODIN Intercom Matrix
Shaft Encoder Operation
Editing Form Data
Throughout the front panel menu system are configuration forms. Forms can be viewed and modified using either the keypad, the
encoder knobs or a combination of both.
Keypad Operation
Action/Mode Home Port Status
Overview
Menu Form (navigating) Form
(navigating)
+ SHIFT)
Left Encoder
Click
Go to STATUS
overview
Go to HOME screen Move up one level Exit form (prompt if
changes)
Double Click
Move to info top Move to info top Go to HOME screen Exit form (abort changes)
Press + Hold
Activate screensaver /
Logout
Activate screensaver /
Logout
Activate screensaver /
Logout
Activate screensaver /
Logout
Rotate
Scroll info up / down Scroll info up / down Move to next / prev
sibling
Scroll form up / down
Right Encoder
Click
Invoke highlighted icon Invoke highlighted
icon
Initiate edit on selected
field
Double Click
Move to info top Go to HOME screen Move up one menu
level
Exit form (save changes)
Rotate
Rotate icon highlight Move icon highlight
left / right
Move to next / prev field
Keypad Character/
Mode
Form (editing):
Text
Form (editing)
+ SHIFT: Text
Form (editing):
Spinner
Form (editing):
Pick List
Form: Check
box
1/STATUS
2/UP
Change character at
cursor
Insert new character
at cursor
Increment value Select next entry Move to prev field
(up)
3/CONFIG
4/LEFT
Change cursor
location
Go to first character Move to prev field
(left)
5/HOME
Toggle letter case Toggle between start
of digits, start of
lowercase letters,
and start of
uppercase letters
Select minimum
value
Select first entry Go to first field (top/
left)
6/RIGHT
Change cursor
location
Go to end of text Move to next field
(right)
7/ALARMS
8/DOWN
Change character at
cursor
Delete character Decrement value Select previous entry Move to next field
(down)
9/SETUP
0/SHIFT
Toggle SHIFT state Toggle SHIFT state Toggle SHIFT state Toggle SHIFT state Toggle SHIFT state
*/CLR
Backspace (delete
previous character
and move backward)
Abort any changes Abort changes Abort changes Exit form (prompt if
changes)
#/SEL
Accept character at
current location and
move to the next
character
Save changes Save changes Save changes Toggle check state
To Next Page
Loading...
