RTS ODIN - Rstp

50 Basic Operation ODIN Intercom Matrix
8. Click Done.
The Frame Mapping Table window closes.
RSTP
RSTP (Rapid Spanning Tree Protocol) is a fault tolerant Ethernet protocol, which allows the system to be set up with multiple
Ethernet connection paths to the same access points. This provides a redundant connection if one connection path fails. The RSTP
connection paths prevent the possibility of packets getting into an infinite loop.
RSTP is an IEEE standardized network protocol (802.1w) ensuring a loop-free topology for an Ethernet LAN (Local Area
Network), evolved from STP (Spanning Tree Protocol). OMNEO fully supports RSTP IEEE802.1w. When using switches that
support this technology, it is necessary to adjust the RSTP parameters of the switch according to the following:
Hello Time: 9 seconds
Maximum Age: 22 seconds
Forward Delay: 30 seconds
This is supported by the major switch brands.
Move Up/Move Down Button The Move Up and Move Down button is used to set the frame order in the
system. The order in which the frames are set determines the ports that are
assigned to each frame.