ODIN Intercom Matrix Menu System Description 145
Name Field
The Name field is used to enter the name of the Intercom System in which SNMP is configured.
This field can contain up to 255 characters.
Location Field
The Location field is used to enter the physical location of the intercom system (for example, 3rd floor, New York).
This field can contain up to 255 characters.
Contact Field
The Contact field is used to enter the name of person responsible for the specified SNMP device.
This field can contain up to 255 characters.
Use Hosts Check Box
The Use Hosts check box determines whether queries are allowed by specified SNMP monitoring devices.
If this check box is selected, then only devices included in the Hosts list are allowed to send SNMP requests to the device. If the
device receives an SNMP request, and the sender’s IP address does not appear in the list of hosts, then the request is silently
discarded.
If the check box is not selected, then the targeted device responds to any and all SNMP requests, no matter the sender’s IP address.
Host 1 though Host 5 Field
The Host 1 through Host 5 fields are used to enter the IP addresses of host machines that can send SNMP requests to the intercom.
Community Strings
Community Strings are used to define the level of security to use when queries are submitted. SNMP Community Strings are like
passwords for network devices.
Most often, there is one community string used for read-only access to a network device. The default value for this community
string is often public.
Read-Only Field
The Read-Only field is used to enter the password that provides read-only access via SNMP.
This field can contain up to 64 characters.
The default entry is public.
Read-Write Field
The Read-Write field is used to enter the password that provides read-write access via SNMP. If the Read-Write field is empty,
SNMP is limited to read-only access.
This field can contain up to 64 characters.
Traps Field
The Traps field is used to enter the trap identifier for the SNMP event monitor. The traps community string specifies the
community string included in all SNMP traps generated by the intercom.
This field can contain up to 64 characters.
The default entry is trap.
To Next Page
Loading...
