SATO E series - Page 48

SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-24
Section 2. Configuration
STEP PROCEDURE
4. Once the copy process is completed, press the ENTER key to step the display.
5. If an error is encountered in the copy process, one of the following messages will
be displayed on the second line.
R/W Indicates a Read/Write error occured.
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
memory->Cardcopy
completed
cardcopy/format
xxxxxxx error
Before a PCMCIA card can be used, it must be formatted. Formatting a card destroys all data
currently used on the card. The initial value is NO (do not format).
Card Format
Yes No
card format
yes no
STEP PROCEDURE
1. Use the keys to step the cursor to either YES or NO.
2. If Yes is selected, the printer will enter the Card Format mode. If No is
selected, the display will advance to the mode display.
Before the internal expanded memory can be used, it must be formatted. Formatting the
memory destroys all stored data. The initial value is NO (do not format).
Memory Format
Yes No
memory format
yes no
STEP PROCEDURE
1. Use the keys to step the cursor to either YES or NO.
2. If Yes is selected, the printer will enter the Memory Format mode. If No is
selected, the display will advance to the mode display.
To exit the Card Mode, power the printer off, then back on.
LCD Panel — Card Mode