SATO E series - Table of Contents

Table of Contents
SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
i
Section 1. Overview and Specifications Page
1 Overview ........................................................................................... 1-1
2 Components ...................................................................................... 1-3
3 Sensors ............................................................................................. 1-8
4 Ribbon ............................................................................................... 1-11
5 Installation Considerations ................................................................. 1-11
6 General Printer Specifications........................................................... 1-12
7 Character Fonts................................................................................. 1-14
8 Bar Codes ......................................................................................... 1-15
9 Physical, Power, Environmental & Approvals ................................... 1-16
10 Accessories and Options................................................................. 1-17
Section 2. Configuration
1 Dip Switch Settings ............................................................................ 2-1
2 Default Settings ................................................................................. 2-8
3 LCD Panel Configuration................................................................... 2-9
Section 3. Interface Specifications
1 Overview ............................................................................................ 3-1
2 Interface Types.................................................................................. 3-1
3 The Receive Buffer............................................................................ 3-2
4 IEEE 1284 Parallel Interface ............................................................. 3-3
5 RS232C Serial Interface.................................................................... 3-5
6 Universal Serial Bus (USB) Interface ................................................. 3-7
7 Local Area Network LAN Optional Interface...................................... 3-8
8 Bi-Directional Communications ......................................................... 3-8
9 Accessory (EXT) Connector.............................................................. 3-8
Section 4. Electrical Checks and Adjustments
1 Overview ............................................................................................ 4-1
2 Steps Prior to Some Procecures ....................................................... 4-2
3 DC Power Voltage Checks................................................................ 4-3
4 Potentiometer Assignments .............................................................. 4-5
5 Adjustment of Eye-Mark Sensor........................................................ 4-6
6 Adjustment of Gap Sensor ................................................................ 4-8
7 Adjustment of Labe Penetrating Sensor............................................ 4-10
8 Adjustment of Paper End Sensor ...................................................... 4-12
9 Adjustment of Pitch Correction (Part 1 .............................................. 4-14
Adjustment of Pitch Correction (Part 2 ............................................. 4-15
10 Adjustment of Front Feed, Back Feed (Tear Off & Cutter ............... 4-17
11 Adjustment of Print Darkness........................................................... 4-18
12 Adjustment of LCD Contrast............................................................ 4-18
13 Checking the Ribbon Sensor........................................................... 4-19