SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-8
Section 2. Configuration
Dip Switch Selections
All switches are placed in the Off position for shipping. This will result in the following
operating configuration.
2.2 Default Settings
Communications: 8 data bits, no parity, 1Stop bit, 9600 Baud
Protocol: Ready/Busy
Sensor: Gap Sensor
Receive Buffer: Multi-Job
Mode: Batch/ Continuous
Label Sensor: Sensor Used
Backfeed: Enabled
External Signals: Enabled
The printer stores any software settings upon receipt and uses them until they are again
changed by receipt of a command containing a new setting. These settings are stored in non-
volatile memory and are not affected by powering the printer off. The printer may be reset
to use the default software settings by depressing the LINE and FEED keys simultaneously
while powering on the printer. This will result in the following default configuration.
SETTING M-10e
Print Darkness 3
Print Speed 5 in. per second
Print Reference Vertical = 0000, Horizontal = 0000
Zero Slash
Auto On-Line Enabled
Feed on Error Enabled
Feed Reprint Enabled
Priority Command
DEFAULT SETTING
COMPLETED
Software Default Settings
Once default operation is completed, a DEFAULT SETTING COMPLETED message will be
displayed on the LCD panel. The printer should be powered off while this message is being
displayed (or after the beep is heard). This saves the default settings in the non-volatile
memeory where they will be automatically loaded the next time the printer is powered on.
To Next Page
Loading...
Need help?
General
