PN 9001098
Rev. A
2-29
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
LCD Panel — Service Mode
Forward/Backward
Distance Default
(Continued)
STEP PROCEDURE
1. Use the keys to step the cursor to either the default or the
Manual selection.
2. Once the correct setting is selected, press ENTER to confirm the
setting and advance to the next display.
3. If the Manual setting is selected, use the cursor keys to advance the
distance to the desired setting. Each time the LINE key is pressed, the
Distance will advance 1 mm. The maximum distance is 255mm.
4. Once the desired distance is set, press the ENTER key to accept the
setting and step to the next display.
This selection allows user to select the conditions that cause the signal on Pin 9 of the EXT
connector to be true. If Mode 1 is selected, Pin 9 will be be true when the printer is ready to
print, i.e., it is Online and has a print job loaded (a quantity of labels to be printed on the
display). If Mode 2 is selected, Pin 9 will ge true if the printer is Online.
Ext Port
Pin 9 Select
ext pin9 select
mode 1 mode2
STEP PROCEDURE
1. Use the keys to select Mode 1 or Mode 2.
2. Once the correct setting is selected, press ENTER to confirm the
settingand advance to the next screen.
This selection allows the user to specify the hexadecimal code for the character which is
replaced with the Euro Character. The default is D5 Hex.
Euro Code
D5
euro code
d5
To Next Page
Loading...
