Cirklon Sequencer User Manual
The Multi option is intended for use with multi-timbral synthesizers which may respond to
MIDI messages on a number of channels at the same time. When multi is enabled, an extra
field to specify the MIDI channel number will appear alongside the instrument assignment on
the track page. This saves any need to redefine the same instrument for each channel it is
active on.
The No Xpose and No FTS options globally disable the effect of any pattern transposition or
force-to-scale for the instrument. This is most commonly used with drum machines or
percussion modules, where specific sounds are mapped to each note number.
The No Edtrk Thru option disables automatic soft-thru of incoming MIDI notes to the
instrument, even if it is assigned to a track selected as the current edit track.
Two further instrument values can be found by scrolling the value selection further, indicated
by the down-arrow at the bottom right:
The CC0=bankM and CC32=bankL options enable the use of CC numbers 0 and 32 for the
bank select MSB and LSB messages which some instruments use in conjunction with MIDI
program change messages to select from more than 128 internal sounds.
When either bank select CC is enabled and a value is in use, it will be transmitted and stored
along with the program change message, as described in the later chapter on Track Values.
To Next Page
Loading...
