Shimadzu AP W-AD Series User Manual

68
66 SettingsSettings
4. Return to the weight measurement mode
Press [ POWER].
 mol Conversion (W-AD/ W/ X Series only)
It is possible to register the sample name and weight value in advance to calculate the load value (g)
/ molecular value and display the result. The sample name can also be output on the screen of via a
printer in alignment with the measurement result (mol unit).
A maximum of ten molecular value units between MOL 0 and MOL 9 can bet registered, and the
names can be amended and entered at random so that they are easily understood.
1.
Press [ UP] for three or more consecutive seconds while in the
weight measurement mode.
The unit registration menu will be displayed.
2. Set the molecular weight unit to ON or OFF
(1) Select any number between [MOL 0 - 9], and then
press [ OK].
(2) Select [on] or [off], and then press [ OK].
· Proceed to Step 3 if [on] was selected.
· Proceed to Step 7 if [off] was selected.
3. Enter the name of the unit
(1) Select [Setting], and then press [ OK].
(2) Select [Sample Name], and then press [ OK].
(3) Enter up to 20 alphanumerals, and then press
[ OK].
^ [Entering Numerals and Characters] (P.43)
4. Enter the sample ID
(1) Select the [Sample ID], and then press [ OK].
(2) Enter up to 10 alphanumerals, and then press
[ OK].
^ [Entering Numerals and Characters] (P.43)

Shimadzu AP W-AD Series Specifications

General

Brand	Shimadzu
Model	AP W-AD Series
Category	Laboratory Equipment
Language	English