13
Product WarrantyProduct Warranty
Aftercare Services and Part Supply Period
1. Aftercare Service
In the event of the product not operating normally, carry out inspections and resolve the problem in accordance with the
instructions providing in (^ [10 Errors and Recovery] (P.152). If the problem persists or other problems that are thought
to be malfunctions not covered by the instructions provided arise, contact the numbers provided on the back cover.
2. Part Supply Period
The period during which replacement parts will be supply for the product is up until seven years after the termination of
manufacture.
Note that there are cases in which it will not be possible to supply replacement parts once this supply period has elapsed.
However, the supply periods stipulated separately by the manufacturers will be applied for parts not manufactured by Shimadzu.
Inspections and Maintenance
Daily inspections, Periodic inspections and regular calibrations are required to ensure that the performance of the balance
is maintained for long periods of time so that correct measurement data can be acquired.
• See [Chapter 11: Maintenance/Inspections] for details on daily inspections and part replacement.
• Contact a Shimadzu sales office or service agency, or one of Shimadzu’s service companies to request Periodic
inspections and regular calibrations.
Product Disposal
When disposing of the product, dismantle and dispose of the parts separately in accordance with their composition in
order in consideration of environmental conservation.
Direct all inquiries to the contact numbers provided on the back cover.
To Next Page
Loading...
Need help?
General
