Shimadzu AP W-AD Series User Manual

124
It is possible to connect an ionizer STABLO AP that irradiates ion in order to eradicate static electricity in
the sample and draft shield. The ionizer is optional and needs to be purchased separately, and it has to be
connected to the balance.
Prohibitions
The W-AD Series comes standard equipped with an ionizer. Removing the
ionizer will void the warranty, so do not remove the ionizer.
Refer to ^ [Turning on the Power to the Ionizer] (P.126) for operation methods.
Connecting the Ionizer (Excluding W-AD series)
The ionizer is connected to the inside of the balance. A screwdriver(+ #2) is required for this procedure.
1.
Switch off the power to the balance, and unplug the AC adapter
from the DC IN connector
2.
Use screwdriver (#2) to remove the screws (4 screws on the
inside) of the backplate.
Precautions
Note: Make absolutely sure to use the screwdriver (#2).
3.
Remove the backplate from the main
balance unit
!
CAUTION
Take care to avoid cutting your fingers on the edge of the backplate.
4.
Turn the knob on the backplate in a counterclockwise direction
to remove the accessory parts
Removing the Accessory Parts
There is a chance that the accessory parts may be needed again after installing the ionizer, so
store them in a safe place.
*
88 IonizerIonizer (STABLO-AP Standard Equippment: W-AD Series ·(STABLO-AP Standard Equippment: W-AD Series · Option: W/ X series)Option: W/ X series)

Shimadzu AP W-AD Series Specifications

General

Brand	Shimadzu
Model	AP W-AD Series
Category	Laboratory Equipment
Language	English