79
1
3
5
2
4
6
7
8
12
14
13
9
10
11
66 SettingsSettings
2. Set the display settings for the operation mode
(1) Select [OP Mode Setting] and then press [ OK].
(2) Select either [Weight display], [OFF display], and
then press [ OK].
Operation Mode Settings
The parameters set will be displayed when in the
balance operation mode.
Weight Display: Displays either the log-in screen or
the weight display screen.
This is used when the balance in incorporated into the measurement system in order to acquire
data from the moment of startup.
OFF Display: Displayed as OFF. Press [ POWER] to display the log-in screen or the weight
display screen.
3. Return to the weight measurement mode
Press [ POWER].
Balance ID Settings
It is possible to set a 16-digit management number (ID) and record logs of all calibrations together
when multiple balances are being managed.
Setting which balance to use for acquiring measurement data is useful for the balance administrator to
identify the calibrations.
1. Call out the System settings
(1) Press [ MENU] while in the weight measurement mode, and then press [ LEFT].
(2) Select [
System settings], and then press [ OK].
(3) Select [System settings], and then press [ OK].
2. Set the balance IDs
(1) Select [Balance ID], and then press [ OK].
(2) Enter the ID, and then press [ OK] (maximum of
16 characters).
^ [Entering Numerals and Characters] (P.43)
3. Return to the weight measurement mode
Press [ POWER].
*
To Next Page
Loading...
Need help?
General
