Shimadzu AP W-AD Series - X84; Brightness Settings; X84; Sound Settings

81
1
3
5
2
4
6
7
8
12
14
13
9
10
11
66 SettingsSettings

Brightness Settings
1. Call out the System settings
(1) Press [ MENU] while in the weight measurement mode, and then press [ LEFT].
(2) Select [ System settings], and then press [ OK].
(3) Select [System settings], and then press [ OK].
2. Set the brightness
(1) Select [Brightness], and then press [ OK].
(2) Select [1 – 5] as the brightness setting, and then
press [ OK].
The higher the value, the higher the luminance,
which makes the display brighter.
3. Return to the weight measurement mode
Press [ POWER].

Sound Settings
A buzzer will let the user know the status of the balance when an operation key is pressed and when
the stability mark is displayed if this function is activated. The buzzer is set to ON or OFF.
1. Call out the System settings
(1) Press [ MENU] while in the weight measurement mode, and then press [ LEFT].
(2) Select [ System settings], and then press [ OK].
(3) Select [System settings], and then press [ OK].
2. Set the sound
(1) Select [Sound], and then press [ OK].
(2) Select either [ON] or [OFF], and then press
[ OK].
3. Return to the weight measurement mode
Press [ POWER].