34
44 Basic OperationsBasic Operations
6. Remove the sample
(1) Open the glass draft shield.
(2) Remove the sample, and then close the glass draft shield.
Close the glass draft shield completely
When reading the results from the balance display, check to make sure that the glass draft
shield is completely closed.
Reading stable weighing values
Troublesome currents of air caused by heat can make the display unstable. Avoid the following:
• Do not place your hand inside the glass draft shield.
• Do not touch the sample or tare (container) with bare hands.
• Do not weigh samples with different temperatures.
Use tweezers or gloves when handling the samples and tares (containers). When weighing
samples with different temperatures, place the samples near the pan inside the glass draft
shield and wait for the temperatures to stabilize before reading the weighing values.
Using a verified balance as a legal measuring instrument in the EU:
Indicates that the balance is set exactly to “Zero” with the zero-setting function.
Using a verified balance as a legal measuring instrument in the EU:
The balance must be used within the temperature range indicated on the verification label.
Ending Measurements
1.
Press [ POWER] when in the weight
measurement mode
The stand-by mode will be activated.
Stand-by mode
A status in which the balance remains on stand-by while saving power so that it is ready to
be used instantly. The term [Stand-by] will be displayed when [ POWER] is pressed in the
weight measurement mode, and the power-saving mode (stand-by mode) will be activated.
Power continues to be supplied to the balance, even when in the eco mode, to maintain the
stand-by mode in this case.
CAUTION
Prohibitions
Do not unplug the AC adapter under any circumstances when
[Communicating] or any other message is displayed on the screen.
Failure to observe this may result in the data stored within the balance being damaged.
Switching off the power
Although it is not necessary to switch off the power under normal circumstances when in the
stand-by mode, if the balance is not to be used for a certain period of time, make sure the
power is switched off.
(1) Activate the stand-by mode.
(2) Unplug the AC adapter from the power outlet.
*
*
*
*
*
*
To Next Page
Loading...
Need help?
General
